ECOVACS ECO D62 Instruction Manual page 142

1) Please make sure the time showing on the LCD is the current time.
2) Check to see that the power switch is turned ON on the bottom of the
The robot fails 3) The robot will NOT work under low battery status. Please keep the robot
to work under
the set time.
4) You may have set the cleaning time to do only once rather than twice,
Turn the Robotic vacuum cleaner off. You may want to reference the various
sections in this Instruction Book for help in accomplishing the following:
A) Remove the Dust Box, empty and clean the filter of any accumulated lint,
dust or dirt.
B) Clean the sensors on each side of the opening.
C) Check to see that the opening in the unit is free from any obstacles so
that dirt can be vacuumed into the Dust Box.
The reduction
D) Reassemble the Dust Box.
of cleaning
E) Turn the unit over and remove the cover and remove the Agitator brush.
ability and the
F) Clean the agitator of any hair, threads, or debris stuck in the agitator
working voice
brushes.
becomes too
G) Clean the recesses for the agitator and make sure there is no obstacle
noisy.
in the agitator opening to prevent dirt from being vacuumed up into the Dust
Box.
H) Clean the 2 dust sensors.
I) Clear the Drive wheels of any obstructions.
J) Vacuum motor is working.
K) Agitator is revolving.
Should the problem continue to exist, call our Service Center for advice.
A) the Robotic vacuum cleaner must be within 16 feet of the Remote Control,
B) Batteries may need replacing in the remote,
C) the cleaner may be in LOW battery and not able to respond,
D) the lenses on the remote and the Robotic vacuum cleaner may have to be
Why does the
cleaned with a dry cloth,
remote control
E) the Robotic vacuum cleaner is too close to the Charging dock or a Virtual
not work?
Wall and their transmitters are interfering with
F) receiving the Remote's signal, or there are other infrared devices, such as
wi-fi router in the immediate area that is interfering with the cleaner receiving
the Remote's signal.
A) Check that the unit was turned ON, remember, the unit will automatically
turn OFF after 2 hours of operation,
Why does B) the batteries could be weak and require changing,
Virtual Wall not C) the length of the beam is 6 feet, so make sure it is covering the entire
work? opening that you want blocked, and
D) make sure the unit is properly placed to confine the area to be cleaned.
ENG - 142
unit.
in the charging dock for charging to ensure normal working for scheduled
working times.
please check the set directions .