Virtual Wall; Battery Placement - ECOVACS ECO D62 Instruction Manual

• Choose certain working mode according to different ground
situation and press corresponding button:
ning Mode/ Fixed Point Cleaning Mode/
Charging Mode
Inteligen voice.
For detailed function, please refer to mode instruction on page 126.
Pause button: Working status, press this button, robot will stop working. Pres the buttom
again, robot will continue.
Direction control key: There are four direction control, ahead, backward, left hand and right
hand. You can use remote control to drive robot to any appointed area under standby mode.
• You can control cleaning mode, going back charging and direction within five meters through
the function key on it.
• If the robot is under cleaning mode or going back charging, please press pause first and then
can proceed direction control.
• During the direction control, robot is not able to operate cleaning.
• Make sure the power supply of remote control is on before you use it. When you use it, match
the signal transmitter with signal receiver on the host.
• If robot is near charger, virtual wall or other infrared transmitter, it would be interfered by
infrared and fails to receive the signal of remote control, under this situation, please manually
operate the mode on the host.

9. VIRTUAL WALL

Battery Placement

Note
►When you use virtual wall, please face marked ECOVACS to the block area you expect.
►Put virtual wall outside of the room you want to block to get best effect.
►The virtual wall would turn off by itself automatically two hours later to save the battery. So
every time the robot start new task , please do check whether the indicator lights.
Automatic Cleaning Mode/
Tips:
• It applies two units of alkaline batteries R20.
• Please note the positive and negative when place the battery
• Change the battery when you notice it is in low battery
and make sure you use the same kind of battery as mixture is
forbidden.
• Take out the battery if you do not use virtual wall for long time
to avoid electrolyte from leaking which may cause failure.
• Do not put the remote control in extremely hot or humid
surroundings.
• Never expose the signal transmitter under sunshine or lighting
equipment, or else it would cause failure.
• The deposal of used battery should conform with local
environmental legislation.
Squelch Cleaning Mode/
ENG
Enjoy smarter life
Border Clea-
Go Back
ENG - 131