Plug In And Power Up; Turn Off The Transport Mode - Muratec MFX-1500 Operating Instructions Manual

Getting started

Plug in and power up

1. Plug one end of the
telephone line cord into
the jack on the
LINE
machine's rear side. Plug
the other end of the cord
into a standard telephone
wall jack, just as you would
plug in a phone.
Note: If you have
purchased an
optional handset,
do not confuse its
curled handset cord with the uncurled telephone line cord.
2. Plug the non-pronged end of the
on the left side of the machine.
3.
Plug the pronged end of the
(preferably on a surge suppressor, as mentioned on page 1.9).
Important: Be sure that you do not turn the power on (next step) until
after you have removed the transport screws (see page 1.10).
4. Use the power switch to turn on your machine. The markings are
AC
international standards: means on,
I
It will take a few seconds for the machine to warm up. The display will show:
** Please Wait **
When the machine is ready to use (standby mode), you will see either . . .
Fax Ready
. . . or . . .
Apr 14 1998 15:30
Fax mode
If the machine beeps, its light glows and the display shows an error
ALARM
message, this means there is a problem of some sort. Please consult "Just in case...,"
beginning on page 3.1.
1.16
power cord into the power cord jack
AC AC
power cord into a 120 electrical outlet
AC VAC
means off.
O
Copy Ready Num: 1
C1:LTR 100%
Copy mode

Turn off the transport mode

Important: Be sure you do not turn the power on until after you remove the
transport screws. (See "Removing the transport screws," page 1.10.)
To turn off the transport mode:
1. Power up the machine.
If the machine is already in Fax mode, skip to step 3.
If the machine is in Copy mode, proceed to step 2.
2.
Press / to switch the machine to Fax mode.
COPY FAX
3. Press , *, .
PROGRAM E
Mirror Locked :On
Program/Enter
4.
Select Off by pressing
PROGRAM
transport mode. The mirror carriage will move to the home position.
Mirror Locked :Off
Program/Enter
Important: If you must reship the machine to any other location, turn on this
mode to move the mirror carriage to the transport position (in step 4,
above, press
PROGRAM
off and mount the mirror carriage using the four transport screws.
. Then press to turn off the
ENTER
to set the transport mode to On), then power