Table of Contents
Advertisement
Getting started
Attach the paper-handling parts
1
Attach the document
tray by inserting it
into the appropriate
holes, as shown.
2
Attach the paper hopper into the
appropriate hole, as shown. Press
gently until the hopper won't go
in any farther.
3
Attach the document hopper by
inserting its two pegs at a slightly
upward angle into the appropri-
ate holes, as shown.
Plug in and power up
1
Plug one end of the telephone line
cord into the
jack on the
LINE
machine's rear side. Plug the other
end of the cord into a standard tele-
phone wall jack, just as you would
plug in a phone.
Note: If you have purchased an
optional handset, do not confuse its curled handset cord with the
uncurled telephone line cord.
Note: We'll get to the
HANDSET
2
Plug the non-pronged end of the
into the
power cord jack on the left side of the
AC
machine (as viewed from the machine's front).
3
Plug the pronged end of the
(preferably on a surge suppressor, as mentioned on page 1.6).
1.8
Document
Paper hopper
hopper
and
.
jacks shortly (see page 1.9).
EXT
TEL
power cord
AC
power cord into a 120
electrical outlet
AC
VAC
4
Use the
power switch to turn on your
AC
machine. The markings are international
standards: I means on, O means off.
Setting the paper size for the multipurpose tray
The multipurpose tray can hold either letter- or legal-sized paper for your machine.
All you have to do is tell the machine which size the tray is using.
Important: If you use a different size from the size you set here, the machine
won't print. Be sure to change this setting whenever you load another
paper size.
Note: The optional paper cassette uses only letter-sized paper.
1
Press
,
, 0, 4,
PROGRAM
J
ENTER
Paper Size:
Letter
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
PROGRAM
size appears. In this example, we've chosen legal-sized paper:
Paper Size:
Legal
Program/Enter
3
Press
to save the setting.
ENTER
Adjust the monitor speaker's volume
You can set the volume of the monitor speaker, assuring that on-hook dialing will
be as loud (or as soft) as you require.
1
Press
/
on the control panel. You now should hear a dial tone,
MONITOR
CALL
and the display will show:
**
Tel Mode
**
_
Important: If you don't hear a dial tone, make sure your fax machine is
plugged into a working phone line.
. The
shows the tray's current setting:
LCD
once or twice until your chosen paper
Advertisement
Table of Contents
