When Using The Fbs - Muratec MFX-1500 Operating Instructions Manual

When using the
FBS
1. If necessary, press /
COPY FAX
Otherwise, proceed to step 2.
2. Open the book cover, place your document face down on the
and align it with the scale on the right.
FBS
Note: Be sure that you place the original document on the
in the same orientation as the paper in the paper source (which
you'll select in step 4, below).
3. Gently close the book cover.
4. Press ? to select recording paper (see page 1.31).
PAPER SIZE
5.
Adjust resolution and contrast if necessary.
Press to change the resolution.
RESOLUTION
Press , then press
CONTRAST
to change the contrast.
Note: For copying, your
only resolution
choices are either
superfine or halftone
mode.
6. Set the reduction or enlargement rate, if you want. (See "Setting of
enlargement or reduction for copying," page 1.34.)
7. If you want to make only one copy of each page of the document, skip to
step 10. Otherwise, proceed to step 8.
8. Use the numeric keypad to enter the desired number of copies for each
page in the document. You may choose one to 99 copies. Here, we've
entered "03" to choose a setting of three copies.
Copy Ready Num: 3
C1:LTR 100%
Note: For fewer than 10 copies, enter a leading zero before the digit —
e. g., "03" (although, as shown above, the zero will not appear in
the final display.)
to change to Copy mode.
FBS
or
Number of copies
9. Press
SORT COPY
copies, as desired.
10. Press
START
COPY FAX
Note: To stop the copying before it is through, press
Note: Thanks to your machine's QuadAccess feature (see page 2.35 for more),
copying doesn't keep you incommunicado while in progress: you can start a
fax or voice call and even receive a voice call during copying.
When using the Multipurpose tray
When you need to use a size of paper not currently loaded in your machine's paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the Multipurpose tray.
Important: If loading transparency (OHP) film into the multipurpose tray, be sure
that the sheet is designed for laser printers and not for copiers. Also,
be sure that the film does not have a paper backing and/or a leading
strip. If it does, remove the paper backing and/or strip before
inserting. Only film should go in, not film with any backing or strip.
1.
Either insert the document in the
2.
Place a sheet of printout paper on the
Multipurpose tray.
Then align the paper guides to the
sheet's edges and insert the sheet
until it comes to a stop.
Note: Place the original
document in the same
orientation as the paper in
the paper source (which
you'll select in step 5, next page).
If you are going to make more than one copy, you should insert the
•
printout paper only one page at a time.
You may use letter-, legal- or half-letter sized paper. (Half-letter is
•
8.5 wide × 5.5 tall.)
once or twice to "Toggle" (switch on or off) the sorting of
to begin the copying process.
STOP
or place it on the
ADF
Getting started
.
.
FBS
1.33