Muratec MFX-1500 Operating Instructions Manual page 87

Beyond the basics
3. Use the numeric keypad to enter the four-digit passcode. In our sample here, we've
entered 2099.
Set PIN Mode
Enter Passcode :2099
Note: If you enter an invalid passcode, the machine's security feature will reject
the attempt and abort the operation.
4. Press .
ENTER
PIN Mode: Off
Program/Enter
If the setting you see is acceptable, skip to step 6.
Otherwise, proceed to step 5.
5. To change the setting, press
PROGRAM
appears. In this example, we've chosen Mode1.
PIN Mode: Mode1
Program/Enter
6. Press .
ENTER
Autodialing while using the mask
PIN
Note: The following instructions presume you are familiar with how to set and use your
machine's autodialer. If you need to review, see pages 2.8–2.16.
Note: If the mask feature is off, you use the autodialer normally.
PIN
If you've specified "Mode1" — the
PIN
In this mode, before autodialing the desired number the first time, you must add the
its stored one-touch key or speed-dial number. Here's how:
1. Make a normal autodialer entry through the entry of the call group(s). The display
will show:
Set PIN Number
Enter Passcode :****
2. Use the numeric keypad to enter the four-digit passcode. Here, we'll use our
sample passcode again:
Set PIN Number
Enter Passcode :6296
3. Press . In our example, we're setting speed-dial number 001:
ENTER
001:PIN Number
_
2.42
repeatedly until your desired setting
goes in
PIN
4. Use the numeric keypad (including either * or #, if necessary) to enter the desired
, up to eight characters in length.
PIN
001:PIN Number
1057_
5.
Press to save the
ENTER
Note: If you press
indicates "Invalid Number" on the display and then returns you to step 3.
Now you may autodial the number as usual.
Important:
While in
PIN
Thus, this applies also to autodialer numbers used with batch transmission
(see pages 2.24–2.27) or programmable one-touch keys (see pages 2.60–
2.70).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission (see
pages 2.24–2.27), you must store the
appropriate batch box.
If you've specified "Mode2" — as you autodial, load the code
In this mode, you don't have to add the
the manually each time you autodial:
PIN
1. Perform the usual autodialing procedure for the number itself. Here, we've entered
speed-dial number 001:
Press Start
S001_
2. Press . The machine now asks for the
START
to
Enter PIN Number
_
3. Use the numeric keypad to enter the
Enter PIN Number
1057_
4. Press . Your machine will dial the number.
START
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission (see
pages 2.24–2.27), you must store the
appropriate batch box.
.
PIN
without entering the , the fax machine beeps,
ENTER PIN
Mode 1, any autodialer numbers you use must include the
access code for the remote unit within the
PIN
to the autodialer setting itself. Instead, you enter
PIN
:
PIN
.
PIN
access code for the remote unit within the
PIN
.
PIN