Power Supply Unit (Psu) - Muratec F-360 Field Engineering Manual

2.4 Power Supply Unit (PSU)

The power supply unit receives the input line voltage and converts it to an output voltages of +5 VDC, +24
VDC, +12 VDC, and -12 VDC.
The heater circuit controls output voltage to the fuser heater according to instructions received from the
heater control circuit.
If an over-current is sensed in the secondary circuit, power is interrupted.
The power supply unit has two output connectors.
The following table shows the connector outputs:
CN1 -- to the Fuser Heater
Pin No. 1 2
Output L N
CN2 -- to the Main Control PCB.
Pin No. 1 2
Output
–12V +12V
voltage
Power supply unit block diagram
3 4 5 6 7
+5V HC1
8 9 10 11
+24V GND
2-6
12 13