Setting For Legal-Sized Paper; Installing Paper - Muratec MFX-1500 Operating Instructions Manual

Getting started

Setting for legal-sized paper

Your fax comes set for letter-sized paper. To set it to use legal-sized paper:
1. Unlock the pin from the upper set of holes by
reaching inside of the paper cassette and pressing
the nib, as shown.
2. Remove the pin.
3.
Insert the pin into the middle
set of holes. You will hear a
click when it is locked
into place.
4. Install the paper guide into
the holes corresponding to
the paper size you are
installing.
Important: Remember, you've now told your fax that the paper cassette holds
legal-sized paper. If you now try to use letter-sized paper without
returning the pin to the upper holes (the setting for letter-sized), your
fax will sound an alarm tone and display the following message when
you try to print:
Check Rx Paper Size
Open&Close Top Cover
5. Be sure to attach the sticker to the outside of the cassette to remind you
LGL
which paper size it contains.
1.14

Installing paper

1. Open the paper
cassette from the front
of your fax by gently
pulling it toward you.
2. Insert the paper into the cassette.
Note: Before you insert paper in the cassette, stack it so the leading edge
and sides of the paper are even.
Make sure the stack of paper isn't higher than the limit mark on the side
•
of the cassette.
Place the edges of the top sheet under the metal tabs on the cassette's
•
left and right side (as viewed from its
front, as shown).
The paper cassette can hold about
•
400 sheets of paper.
Note: Each of the two optional
additional cassettes can
hold about 200 sheets of
paper. Thus, you can have
as many as 800 sheets of
paper "on-line." For more
details on these and other options for your fax machine, please
contact your authorized Muratec dealer.