Table of Contents
Advertisement
Aligning Automatically and Cutting
This section describes how to make settings when using the BN-20 driver. When using Roland VersaWorks,
refer to the "Roland VersaWorks Quick Start Guide".
*You cannot make this setting using the BN-20 driver on a white ink model. Refer to Help of Roland VersaWorks.
Procedure
Print with a crop mark, and then reload the media that was removed.
P.35, "Printing with Crop Marks"
Points for Media Setting
Place the crop marks on the blade protector.
Angled no more than 5 degrees. Otherwise alignment becomes impossible.
Crop marks
Performing Printing and Cutting Separately
Blade protector
Set to 5° or less.
Chapter 2 Fully Utilizing the Machine
37
Advertisement
Table of Contents
