Aligning Automatically And Cutting - Roland VersaStudio BN-20 Master Manual

Aligning Automatically and Cutting

This section describes how to make settings when using the BN-20 driver. When using Roland VersaWorks,
refer to the "Roland VersaWorks Quick Start Guide".
Procedure

Print with a crop mark, and then reload the media that was removed.
 P. 35, "Printing with Crop Marks"
Points for Media Setting
Place the crop marks on the blade protector.
Angled no more than 5 degrees. Otherwise alignment becomes impossible.
Crop marks
Chapter 2 Fully Utilizing the Machine
Performing Printing and Cutting Separately
Blade protector
Set to 5° or less.
37