Table of Contents
Advertisement
Printing
This section describes operations when printing only. Refer to page 28 "Cutting / Printing & Cutting" and page
35 "Performing Printing and Cutting Separately."
STEP 1: Loading Media
Roll media
Procedure
Push the loading lever backward.
Move the left media guide to the left.
Left media guide
Media bar
Hole
Media flange
Load the roll media onto the media bar.
Press the media flanges into the paper tube at both ends. Place the fixed media flange at the bottom, so
that the media feeds in a clockwise direction when looking from above. You cannot set the media cor-
rectly if the feed direction is not correct.
Push in
Loading lever
Mounting pin
Push in
Attach the media flange to one end of
the media bar.
Insert the side of the media bar with a hole into
the media flange, and secure it with the mounting
pin. Use one of the two media flanges. The inside
should be the one that fits the inner diameter of
the roll media paper tube.
Make sure that there are no gaps.
Chapter 1 The Basics
15
Advertisement
Table of Contents
