Motor Error; Data Error - Roland VersaStudio BR-20 Master Manual

Sign maker

Table of Contents

Handling Messages and Error Messages

[Motor error ]

A motor error occurred.

Operation cannot be continued. By following the messages displayed in the Utility window, remove the

media, close the front cover, and then hold down the POWER key to switch the sub power off. This error may

be caused by such factors as an incorrect loading of the media, a media jam, or an operation that pulls the

media with excessive force. Eliminate the cause of the error before switching the sub power on, and then

reload the media.

[Waste cartridge is estimated to be full]

Output is stopped because the waste cartridge is full

Output cannot be resumed without correcting this error. Replace the waste cartridge with a new one by fol-

lowing the message displayed in the Utility window. If a new waste cartridge is not available for immediate

replacement, switch the main power off.

[Temperature error ]

The temperature of the location where the machine is installed has risen above or fallen

below the ambient temperature at which the machine can operate.

Operation cannot be continued. Switch off the sub power. Bring the installed location to a temperature at which

operation is possible (20 to 32°C) and allow the machine to come to room temperature, then turn on the power.

[Cover open error. ]

Output is stopped because the front cover or the maintenance cover is open.

Start output again after closing the cover.

[Sheet setup error ]

Setup of the media has failed. Load the media correctly.

 P.15, "STEP 1: Loading Media"

Output was stopped because a problem was found in the data received.

Operation cannot be continued. Check for errors in the data. Check for a problem with the connector cable

or the computer, and start output again.

[Ink has run out.]

Output is stopped because ink has run out.

In the [Ink] tab of the Utility window, check the color of the cartridge that has run out of ink, and replace the

ink cartridge with a new one.

 P.69, "Checking Ink Levels,"p.70, "How to Replace Ink Cartridges"

Chapter 4 Appendix

Table of Contents