Aligning Automatically And Cutting - Roland VersaCamm SP-300V User Manual

4-7 Using the Crop-mark Feature

Aligning Automatically and Cutting

When you make the setting for reading crop marks when sending cutting data from the computer, alignment is per-
formed with the presence or absence of crop marks determined automatically.
For information on how to make the setting, refer to the documentation for the software RIP you're using.
Procedure
Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the figure appears and operation stops.
CROPMARK ERROR
If this happens, press
Reload the media, then send the data again.
If this does not resolve the problem, then perform alignment manually.
p 83 "Aligning Manually and Cutting"
If the crop marks cannot be detected easily because of the effects of media warping or the like, then perform alignment
manually.
When you want to perform automatic alignment with lengthy media, we recommend performing output with the data
separated into sizes that are as short as possible. With large sizes, error due to warping and the like increases, making
smooth detection impossible.
82 Chapter 4 Feature Reference
Crop marks
NOT FOUND
, then take action as follows.
Load the media.
Blade protector
5 degrees Angled no more than 5 degrees.
Otherwise alignment becomes
impossible.
5 degrees