Table of Contents
Advertisement
About the Blade
The cutting conditions and the service life of the blade change according to the media and the operating
environment, even when you're using identical blades. The service life also differs according to the type of
blade. A rough guide is shown below.
Blade
ZEC-U1005
ZEC-U5025
When uncut areas remain even when the blade force is increased to a value that is higher by 50 to 60 gf than
the values shown in this chart, then replace the blade.
*The values for "Blade life" are estimates for when an identical type of media is used.
Locations of the Power Rating and Serial Number Labels
Media
General signage
vinyl
General signage
vinyl
Fluorescent vinyl
Reflective vinyl
Serial Number
This is required when you seek maintenance, servicing, or sup-
port. Never peel off the label or let it get dirty.
Power Rating
Use an electrical outlet that meets the requirements for voltage,
frequency, and amperage given here.
Blade force
Amount of
blade offset
50 to 150 gf
0.25 mm
30 to 100 gf
0.25 mm
120 to 200 gf
0.25 mm
100 to 200 gf
0.25 mm
Main Specifications
Blade life*
(general
guide)
8000 m
4000 m
4000 m
4000 m
Chapter 4 Appendix
101
Advertisement
Table of Contents
