Installing An Nxd Into An (Optional) Rack Mount Kit (Nxa-Rk12 Or Nxa-Rk15) - AMX NXD-1700VG Instruction Manual

Install the four (#4)
mounting screws
into the holes
(screws not included)
A - Faceplate
Wall Mount panel installation configuration for flat/solid surfaces
FIG. 45
10. Reinstall the magnetic faceplate (A in FIG. 45) back onto the main NXD unit (B in FIG. 45).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/
faceplate.
11. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the
NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
12. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

Installing an NXD Into an (Optional) Rack Mount Kit (NXA-RK12 or NXA-RK15)

1. Remove the magnetic faceplate/bezel from the main NXD unit by gripping the faceplate and pulling with gentle outward force.
2. Thread the incoming RJ-45, Ethernet, USB, and any optional audio/video wiring through the opening in the equipment rack
(from their terminal locations). Refer to the Wiring Guidelines for the 1200VG and 1500VG Panels section on page 56 for
pinout descriptions. Leave enough slack to accommodate any re-positioning of the panel.
3. Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch
panel.
Verify the terminal end of the power cable is not connected to a power supply before plugging in the 2-pin power

connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

4. Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify the panel
is receiving power and functioning properly to prevent repetition of the installation.
5. Disconnect the terminal end of the power cable from the connected power supply.
NOTE: Don't disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before
being inserted into the equipment rack.
6. Insert the main 12-inch Modero unit into an NXA-RK12 (FIG. 46) or the 15-inch Modero into an NXA-RK15 (FIG. 47).
Modero VG Series Touch Panels - Instruction Manual
Attachment is done
along the edges of
the cutout
(bezel)
Installation Procedures: 12" and 15" Panels
B - Main NXD unit consists of
the touch panel and housing
Flat surface
(can include a
wall, podium, or
other flat
surface)
54