Step 2: Install The 802.11G Mini-Pci Wireless Card - AMX NXD-1700VG Instruction Manual

5. Gently tilt the LCD backward to a 45° angle.
6. In a single motion, carefully pull the outer housing up and then out (away from the LCD panel) to expose the internal circuit
board (FIG. 19). The NXA-RGB card is available within both the optional RGB Kit and NXA-RGBKIT upgrade.
7. Unscrew the Stereo Output nut from the Stereo Output jack.
8. Firmly grab the existing connector plate and slide it up and away from the base. This part is later replaced with the RGB
connector plate.

Step 2: Install the 802.11g mini-PCI Wireless Card

1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the mini-PCI card connector on the main board (FIG. 16 and FIG. 17).
NXA-PCI80211G
wireless card
I/O connector
Eight Housing
Screws
Location of the NXA-PCI80211G wireless card on the NXT board
FIG. 16
Location of the mini-PCI card connector on main board
FIG. 17
NOTE: If you have previously installed an NXA-RGB card, it must f irst be removed prior to gaining access to the mini-PCI
connector on the board.
3. Carefully remove the gold-tipped terminal ends of the antenna from their factory default connectors on the main board. The
antenna is secured at this location to restrict its movement prior to connection to a wireless card.
4. Firmly grasp the NXA-PCI80211G mini-PCI card (from the edges) and insert the pins (at a 25° angle) into the opening on the
connector (FIG. 18).
5. While maintaining the 25° angle alignment on the new module, push it in firmly until the contact pins are completely inside the
connector and the card "snaps" into place (FIG. 18).
6. Push the card downward (to the main board) until the side braces snap atop the NXA-PCI80211G and hold it in place.
Modero VG Series Touch Panels - Instruction Manual
location
plate
Touch Panel Accessories
Outer Housing
Compact Flash card
34