Master Connection Section - Netlinx Master Ethernet Ip Address - Auto Mode; Using G4 Web Control To Interact With A G4 Panel - AMX NXD-1700VG Instruction Manual

4. Enter a username and password (into their respective f ields) if the target Master has been previously secured.
5. Select the OnLine Tree tab from the Workspace window.
6. Select Diagnostics > URL Listing from the Main menu (FIG. 84).
System Address reflects the value
set in the Device Addressing tab
Click to set the URL List on Master
URL List dialog
FIG. 84
7. Enter the System and Device number for the specific Master associated with your panel (as seen in the Online Tree tab).
8. Click Add and enter the IP Address of the Modero touch panel into the Add URL dialog box.
9. Click OK to enter your IP Address and add it to the list.
10. Click Done once you are finished adding your panel information to the list.
11. Press the on-screen Reboot button to save any changes and restart the panel.

Master Connection section - NetLinx Master Ethernet IP Address - Auto Mode

In this mode, enter the System Number of the NetLinx Master. This mode instructs the Modero to search for a Master that uses the
same System Number (assigned within the Master Connection section) and resides on the same Subnet as itself.
1. Toggle the blue Type field until Ethernet is selected (from the Master Connection section of the System Settings page).
2. Press the Mode field until the choice cycles to the word Auto.
3. Press the System Number field to launch a Keypad and enter the value for the system number of the NetLinx Master. This value
can be obtained from the NetLinx Studio program > OnLine Tree of the Workspace window.
4. Do not alter the IP Settings section, of the System Settings page, as these fields are not applicable to this connection mode.
5. Enter a username and password (into their respective f ields) if the target Master has been previously secured.
6. Press the on-screen Reboot button to both save any changes and restart the panel.
7. Press the grey Front Setup Access button for 3 seconds to open the Setup page and confirm there is an active connection.
NOTE: The NetLinx Master and the Modero panel must both be on the same Subnet.

Using G4 Web Control to Interact with a G4 Panel

The G4 Web Control feature allows you to use a PC to interact with a G4 enabled panel via the web. This feature works in tandem
with the new browser-capable NetLinx Security firmware update (build 300 or higher). G4 Web Control is only available with the
latest Modero panel firmware.
Refer to the G4 Web Control Settings section on page 122 for more detailed field information.
NOTE: Verify your NetLinx Master (ME260/64 or NI-Series) has been installed with the latest f irmware KIT f ile from www.amx.com.
Refer to your NetLinx Master Instruction Manual for more detailed information on the use of the new web-based NetLinx Security.
1. Press the grey Front Setup Access button for 3 seconds to open the Setup page.
2. Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display
an on-screen keypad.
3. Enter 1988 into the Keypad's password field (1988 is the default password).
NOTE: Clearing Password #5, from the initial Password Setup page, removes the need for you to enter the default password
before accessing the Protected Setup page.
4. Press Done when finished.
5. Press the G4 Web Control button to open the G4 Web Control Settings page (FIG. 85).
Modero VG Series Touch Panels - Instruction Manual
Click to obtain an existing
URL List from Master
Configuring Communication
88