Upgrading Accessory Devices Via An Ip Address - AMX NXD-1700VG Instruction Manual

Send to NetLinx Device dialog (showing Modero firmware update via IP)
FIG. 95
7. Select the panel's KIT file from the Files section (FIG. 95).
8. Enter the Device value associated with the panel and the System number associated with the Master (listed in the OnLine Tree
tab of the Workspace window). The Port f ield is disabled.
9. Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update process is complete. The
reboot of the panel can take up 30 seconds after the f irmware process has f inished.
10. Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog (FIG. 95).
11. Click Close (after the panel reboots) to return to the main program.
12. Right-click the associated System number and select Refresh System. This causes a refresh of all project systems, establishes
a new connection to the Master, and populates the System list with devices on your particular system.

Upgrading Accessory Devices via an IP Address

The following accessory devices are firmware upgradeable:
NXA-BASE/B Battery Base (FG2255-10)

NXA-RGB card (FG2260)

NXA-AVB/RGB Breakout Box (FG2254-11)

These devices are not given a unique device numbers which would ordinarily appear within the Online Tree tab of NetLinx Studio.
They appear below the target which they are either communicating with (NXA-AVB/RGB) or a part of (NXA-BASE/B or NXA-RGB
card) as seen below in FIG. 96.
NetLinx Studio Online Tree tab
Location of Firmware version information within NetLinx Studio
FIG. 96
Modero VG Series Touch Panels - Instruction Manual
Selected Firmware file
Target Panel Device #
NXA-RGB
firmware
NXA-AVB/RGB
(BOB version)
Description field for selected KIT file
Firmware download
status
Device value and System number
must match the values listed in the Workspace window
Accessory's corresponding firmware page
Upgrading Modero Firmware
97