Testing Calibration - AMX NXD-1700VG Instruction Manual

3. After the "Calibration Successful." message appears, press anywhere on the screen to continue and return to the Setup page.
NOTE: If the calibration was improperly set and you cannot return to the Calibrate page (through the panel's f irmware); you can
access this f irmware page via G4 WebControl where you can navigate to the Protected Setup page and press the Calibrate
button through your VNC window. This action causes the panel to go to the Calibrate page seen above, where you can physically
recalibrate the actual touch panel again using the above procedures.

Testing Calibration

1. Press and hold down the on-screen Calibration button for 6 seconds to enter the Calibrate page.
2. Press anywhere on this page to confirm the on-screen crosshairs match your touch points.
3. If the crosshairs do not appear directly below your LCD touch points, press the Back button and recalibrate the panel using the
above steps.
4. Exit the Calibrate page by pressing the Back button to return to the Protected Setup page.
Modero VG Series Touch Panels - Instruction Manual
Panel Calibration
73