Setup Page - AMX NXD-1700VG Instruction Manual

Setup Page

This page (FIG. 101) centers around basic Modero panel properties such as: Connection Status of the panel, Display Timeout,
Inactivity Page Flip Time, Inactivity page file, and the Panel Brightness.
Setup page
FIG. 101
The elements of the Setup page are described in the table below:
Setup Page Elements
Exit:
Connection Status icon:
Connection Status:
Display/Panel Timeout:
Inactivity Page Flip
Timeout:
Panel Brightness:
Modero VG Series Touch Panels - Instruction Manual
Returns you to the Main touch panel page. In this case, the previous page is the default Main page.
This visual display of the connection status allows the user to have a current update of the panel's connection
status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a currently secured target
Master (requiring a username and password).
Displays whether the panel is communicating externally, the encryption status of the communicating Master,
what connection type is being used (Ethernet or USB), and what System the panel is a part of.
This visual display of the connection status is also reflected at the upper-right of each firmware page. This
allows the user to have a current visual update of the panel's connection status regardless of what page is
currently active.
• When a connection is established, the message displayed is either "Connected via Ethernet " or "Connected
via USB ".
• If no connection can be established by the Modero panel, it will continue to try and establish a connection
while displaying: "Attempting via ...".
• The word "Encrypted" appears only when an encrypted connection is established with a target Master.
• The panel must be rebooted before incorporating any panel communication changes and detecting any
active Ethernet connections. The Ethernet connection is not detected until after a reboot.
Sets the length of time the panel can remain idle before activating the sleep mode. When the device goes into
sleep mode, the LCD is powered-down.
• Press the UP/DN buttons to increase/decrease the time until the panel
times out. Range = 0 - 240 minutes.
• Use this button to set the timeout value to zero and disable the sleep mode.
• Note: Display timeout values affect battery performance. Small timeout values increase the life of the battery
charge. Greater timeout values may require more frequent battery charging.
Sets the number of minutes of inactivity before the panel automatically flips to a pre-selected touch panel
page. When the device goes into this inactivity mode, the LCD does not power-down.
• Press the UP/DN buttons to increase/decrease the time the panel can remain inactive before it flips to the
preset page. Range = 0 - 240 minutes.
• Use this button to set the timeout value to zero and disable the inactivity page flip mode.
• The touch panel page used for the Inactivity page flip is shown within a small Inactivity Page field.
Sets the display brightness level of the panel.
• Press the UP/DN buttons to adjust the brightness level. Range = 0 - 100.
• The on-screen bargraph can be dragged to adjust the Brightness level which is then reflected as a
corresponding numeric value within the Panel Brightness field.
Firmware Pages and Descriptions
Connection Status
Red Connection Status icon -
indicates no connection to a Master
Green Connection Status icon -
indicates communication to a Master
Video button doesn't
appear on Non-Video (CA) panels
Battery Base button doesn't appear
until NXT is connected to a BASE/B
102