Panel Calibration; Overview; Calibrating The Modero Panel - AMX NXD-1700VG Instruction Manual

Panel Calibration

Overview

This section outlines the steps for calibrating the touch panel. It is recommended that you calibrate the panel before its initial use
and after completing a f irmware download.
Modero panels are factory setup with specific demo touch panel pages. The first splash screen that appears indicates the panel is
receiving power, beginning to load firmware, and preparing to display the default touch panel pages. When the panel is ready, the
AMX Splash Screen is replaced by the Initial Panel Page (FIG. 65).
(appears during power-up)
AMX splash screen and Initial Panel Page
FIG. 65

Calibrating the Modero Panel

1. Press and hold the grey Front Setup Access button (FIG. 66) for 6 seconds (passing-over the Setup page) to access the
Calibrate page (FIG. 67). The panel should f irst be calibrated properly.
Front Setup Access button
Location of grey Front Setup Access button
FIG. 66
2. Press the crosshairs (on the Calibrate page) to set the calibration points on the LCD (FIG. 67).
Touch Panel Calibration Screens
FIG. 67
Modero VG Series Touch Panels - Instruction Manual
AMX Splash Screen Initial Panel Page
(AMX Logo Page)
Single press puts the panel to sleep
3 second press/hold: Accesses the Setup page
6 second press/hold: Accesses the Calibration page
The request to touch the crosshairs
is the first on-screen message
Calibration successful is the second
on-screen message that appears
after the calibration process is
completed
On-screen crosshairs used for
calibration of the touch device
Panel Calibration
72