Installing An Nxd Into An (Optional) Rack Mount Kit (Nxa-Rk17) - AMX NXD-1700VG Instruction Manual

Installing an NXD Into an (Optional) Rack Mount Kit (NXA-RK17)

1. Remove the magnetic faceplate/bezel from the main NXD unit by gripping the faceplate and pulling with gentle outward force.
2. Thread the incoming RJ-45, Ethernet, and any optional audio/video wiring (from their terminal locations) through the opening
in the equipment rack. Refer to the Wiring Guidelines for the 1700VG Panels section on page 70 for pinout descriptions. Leave
enough slack to accommodate any re-positioning of the panel.
3. Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch
panel.
Verify the terminal end of the power cable is not connected to a power supply before plugging in the 2-pin power

connector.
4. Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify the panel
is receiving power and functioning properly to prevent repetition of the installation.
5. Disconnect the terminal end of the power cable from the connected power supply.
NOTE: Don't disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before
being inserted into the equipment rack.
6. Insert the main 17-inch Modero unit into the NXA-RK17 (FIG. 62).
NXD-1700VG Wall Mount panel installed into an NXA-RK17 Rack Mount Kit
FIG. 62
7. Secure the panel to the NXA-RK17 mount frame by first inserting and then tightening the four #4-40 screws.
8. Insert the NXA-RK17 (with connected NXD unit) into the equipment rack, making sure to align the screw holes along the sides
of the NXA-RK17 with the holes in the equipment rack.
9. Use a grounded Phillips-head screwdriver to secure the NXA-RK17 to the equipment rack using #10-32 screws (not included).
10. Place the magnetic faceplate back onto the main NXD unit by gripping the faceplate and placing it on the housing with gentle
force. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/
faceplate.
11. Reconnect the terminal RJ-45, Ethernet, and any optional audio/video wiring to their respective terminal locations on either
the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
12. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
Modero VG Series Touch Panels - Instruction Manual
482.60
19.00
Installation Procedures: 17" Panels
399.29
15.72
84.03
3.31
69