Connecting and Using USB Input Devices
These panels can have up to two USB-capable input devices connected for use both on its different firmware and TPD4 panel
pages. These input devices can consist of a keyboard or mouse.
NOTE: USB-connected input devices are detected and recognized by the panel upon connection. Refer to the Conf iguring and Using
USB with a Virtual Master section on page 75 for more information on using a USB connection.
1.
Insert the input device USB connectors into the appropriate USB connector on the panel.
2.
Press the on-screen Reboot button (Protected Setup page) to save any changes and restart the panel.
3.
After the panel splash-screen disappears:
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location corresponds to the
mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any external keystrokes sent
from the external USB keyboard.
Cleaning the Touch Overlay
You should clean the touch screen overlay after each day's use.
Always use clean cotton cloths and a spray bottle containing water.
Modero VG Series Touch Panels - Instruction Manual
Modero VG Series Touch Panels
20