Step 5: Close And Re-Secure The Nxt Panel Enclosure; Installation And Upgrade Of The Internal Nxd Components; Step 1: Remove The Existing Nxd Outer Housing; Step 2: Install The New 802.11G Mini-Pci Wireless Card (Nxd) - AMX NXD-1700VG Instruction Manual

Step 5: Close and Re-secure the NXT Panel Enclosure

1. Obtain the new RGB I/O connector plate (similar to the original but containing the added RGB connector opening to the newly
installed NXA-RGB) and slide it back into position.
2. Re-secure the Stereo Output nut back onto the new Stereo Output jack onto the new RGB I/O plate.
3. With the components securely installed, tilt the LCD back to a 45° and then gently slide-on the outer housing (towards the
LCD) until the it is aligned over the installation holes and the tilt bracket prevents any further forward movement (FIG. 19).
4. Gently press down on the housing (toward the base) until it is securely positioned over the circuit board and cover base.
NOTE: Use caution when re-installing the outer housing. Improper re-installation can cause damage to the internal speakers.
5. While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown on a soft cloth and the
under-side of the base is exposed.
6. Insert and secure the eight Housing Screws (using a grounded Phillips-head screwdriver) into their respective locations
(FIG. 15).
7. Replace any adhesive plastic "feet" that might have been removed during the removal process of the outer housing. These
"feet" must be placed back onto their original locations so they can f it into their provided openings on the Battery Base.
8. Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.
9. Insert all connectors and apply power.

Installation and Upgrade of the Internal NXD Components

Upgrading the components within a WallMount panel involves removing the rear plastic outer housing (back box), removing and/or
installing an existing component, and then placing the back box back onto the NXD panel, as described in the following sections.

Step 1: Remove the existing NXD Outer Housing

1. Carefully detach all connectors from the side of the touch panel and remove the front magnetic faceplate from the NXD unit by
firmly gripping the faceplate and pulling outwards, while applying a small amount of pressure to remove it from the main unit.
2. Place the LCD face-down onto a soft cloth to expose the under-side of the unit. This step helps prevent scratching of the LCD.
3. Unscrew the Stereo Output nut from the Stereo Output jack.
4. Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide the I/O
connector plate away from the back box housing.
NOTE: DO NOT REMOVE THE PANEL SECURING SCREWS. These screws secure the LCD to the metallic casing.
5. Unscrew the four pan-head Housing Screws from the rear of the NXD unit (FIG. 22) and gently remove the outer housing.
These four screws secure the back box to the internal panel casing.
DO NOT
REMOVE
these
panel
securing
screws
Location of the securing screws on an NXD panel
FIG. 22

Step 2: Install the new 802.11g mini-PCI Wireless card (NXD)

Complete the procedures outlined within Step 2: Install the 802.11g mini-PCI Wireless Card section on page 34 and then continue
with the following step.
Modero VG Series Touch Panels - Instruction Manual
DO NOT REMOVE
these panel
securing screws
Unscrew these four Housing Screws
to remove the back box.
These make direct contact with the black
outer housing.
Touch Panel Accessories
37