Nxa-Rgb Rgb/Vga Interface Card (Fg2260) - AMX NXD-1700VG Instruction Manual

NOTE: All 1200V-Series, VG-Series, and Table Top CV10 panels require the installation of an appropriate number of CAT5 Suppression
Ferrites when they use an RJ-45 cable to feed an A/V signal from the breakout box.
1. The CAT5 Suppression Ferrite is housed within a plastic enclosure (shown in FIG. 10) with a latch release on one side. Pull to
release the latch and open the enclosure.
2. Grasp the Black RJ-45 Audio/Video cable being connected to the panel. This end of the cable is longer than the opposing end
which connects to the breakout box (6 inches vs 3 inches). Refer to FIG. 11 for more detailed information.
3. Insert the panel-end of the Black RJ-45 Audio/Video cable into the groove along the inside of the enclosure.
NOTE: The CAT5 Suppression Ferrites MUST be installed onto the cable connected to the Modero's Audio/Video RJ-45 connector
(just behind the connector).
4. Snap the enclosure shut with the cable inside, and you're done.
5. Repeat this process again only when installing an additional CAT5 Suppression Ferrite (model specif ic).
To Touch
Panel
Connector 1 - used for Audio/Video (Black)
Connector 2 - used for Ethernet (White)
Ferrite connector location on Audio/Video RJ-45 cable
FIG. 11
NOTE: It is recommended that any upgrade of internal components be done simultaneously in order to reduce the risk of damage to
internal components. If a user will be upgrading an NXD panel with a wireless card and an NXA-RGB card (NXA-RGBKIT), it is
recommended that these both be done at the same time if possible.

NXA-RGB RGB/VGA Interface Card (FG2260)

The NXA-RGB (FIG. 12) is an RGB/VGA plug-in interface card that allows any of AMX's VG-Series Modero Touch Panels to accept
either RGB or HDTV Component signals directly from an external source when routed through an optional NXA-AVB/RGB Breakout
Box. This card is field upgradeable and works in-tandem with the RGB connector on the front of an NXA-AVB/RGB Breakout Box.
NXA-RGB RGB/VGA Interface Card (installed within a VG-Series panel)
FIG. 12
The NXA-RGB card is an optional accessory (already installed within Video/RGB panels) that can be added to any VG-Series Video
Modero panel as part of an upgrade kit. The NXA-RGB card is a daughter card that plugs into the Modero's main board. This card
provides the ability to display computer graphics (RGB) or component (YCrCb) video within a full screen or resizable on-screen
window on the Modero panel. The NXA-RGB card must be used with the NXA-AVB/RGB Breakout Box. This breakout box allows the
Modero to accept and display high-bandwidth and high-quality RGB as well as HDTV Component video signals. This box then
converts the RGB or component video so that it can be sent across a UTP (unshielded twisted pair) cable to the from the rear RGB/
Component DB-15 connector (rear of the box), through the front RGB RJ-45 connector, and then to the panel via the RJ-45
connector on the installed NXA-RGB card.
Modero VG Series Touch Panels - Instruction Manual
3
2
1 Ferrite Ferrite
4
6 inches
Connector 3 - used for Power
Connector 4 - used for RGB (Blue)
Touch Panel Accessories
29