Installing The Mp-Tp12/15 Back Box - AMX NXD-1700VG Instruction Manual

DO NOT
REMOVE
these
panel
securing
screws
Location of the attachment screws on the NXD back box
FIG. 33
NOTE: DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure the LCD to the metallic casing underneath.
7. Lift the back box housing to separate it from the internal panel casing.

Installing the MP-TP12/15 Back Box

1. Unscrew the four pan-head Housing screws (#8-32) from the MP-TP12/15 rear plastic cover.
2. Gently place the MP-TP12/15 back box over the internal panel casing (with the cable routing hole on the right-side of the
panel).
3. Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the MB-TP12/15 back
box (FIG. 34) and secure them using a grounded Phillips-head screwdriver.
4. Place the I/O connector plate back over the connector opening and align the connector locations.
5. Re-secure the I/O connector plate (using a grounded Phillips-head screwdriver) and re-secure the Stereo Output nut on the
Stereo Output jack.
Twelve
#6-32
securing
screws
Location of the attachment screws on the NXD back box and VESA housing
FIG. 34
Modero VG Series Touch Panels - Instruction Manual
DO NOT REMOVE
Securing
hole locations
(3 on each side)
Internal panel casing
Four (pan-head) Housing Screws
DO NOT REMOVE
these panel
securing screws
Unscrew these four Housing Screws to remove the back box.
These make direct contact with the black outer housing.
MB-TP12/15 back box
Connector
Opening
Rear plastic cover
Installation Procedures: 12" and 15" Panels
Strain relief grommet (Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
Four (#8-32) screws
45