Installing The Mp-Tp12/15 Back Box - AMX Modero NXD/NXT-1200VG Operation/Reference Manual

Installation Procedures: 12" and 15" Panels
5.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws
and slide the I/O connector plate away from the back box housing.
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 33). These screws secure
the back box to the internal panel casing.
DO NOT
REMOVE
these
panel
securing
screws
FIG. 33 Location of the attachment screws on the NXD back box
DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure
the LCD to the metallic casing underneath.
7.
Lift the back box housing to separate it from the internal panel casing.

Installing the MP-TP12/15 Back Box

1.
Unscrew the four pan-head Housing screws (#8-32) from the MP-TP12/15 rear plastic cover.
2.
Gently place the MP-TP12/15 back box over the internal panel casing (with the cable routing hole on the
right-side of the panel).
3.
Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the
MB-TP12/15 back box (FIG. 34) and secure them using a grounded Phillips-head screwdriver.
4.
Place the I/O connector plate back over the connector opening and align the connector locations.
5.
Re-secure the I/O connector plate (using a grounded Phillips-head screwdriver) and re-secure the Stereo
Output nut on the Stereo Output jack.
46
DO NOT REMOVE
these panel
securing screws
Unscrew these four Housing Screws
to remove the back box.
These make direct contact with the black
outer housing.
VG-Series Modero Touch Panels