04AKENG59_H3T.fm Page 101 Thursday, July 31, 2008 12:07 PM
■ MULTIFUNCTION
LEVER
Turn Signal
To signal a turn, move the lever all
the way up or down. When the
turn is over, the lever will return
automatically.
To signal a lane change, just raise
or lower the lever until the arrow
starts to flash. Hold it there until
you complete your lane change.
An arrow on the instrument cluster
will flash in the direction of the
turn or lane change.
If the arrows flash at a faster rate
than normal, a signal bulb may be
burned out. Check the front and
rear signal lights to make sure they
are working properly.
If a bulb is burned out, replace it. If
the bulb is not burned out, check
the fuse.
See "Fuses and Circuit Breakers" in
Section 4 for additional informa-
tion.
Section 1
If a turn signal is left on for more
than 1.2 km (3/4 mile), a chime
will sound and the TURN SIGNAL
message will appear on the Driver
Information Center display to
remind you to turn it off. If you
need it on longer, turn the signal
off, then back on.
101 . . .
–