Turn Signal/Multifunction Lever; Turn And Lane-Change Signals - Hummer 2007 H2 Owner's Manual

Turn Signal/Multifunction Lever

The lever on the left side of the steering column
includes the following:
•
Turn and Lane Change Signals. Turn and
G
Lane-Change Signals on page 178.
•
Headlamp High/Low-Beam Changer.
53
Headlamp High/Low-Beam Changer on
page 179.
•
Flash-to-Pass Feature. See Flash-to-Pass on
page 180.
178
•
Windshield Wipers. See Windshield
N
Wipers on page 180.
•
Windshield Washer. See Windshield
L
Washer on page 181.
I
•
Cruise Control. Cruise Control on
page 183.
For information on the exterior lamps, see Exterior
Lamps on page 186 later in this section.

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
To signal a lane change, raise or lower the lever for
less than one second until the arrow starts to flash.
This will cause the turn signals to automatically
flash three times. It will flash six times if the
tow-haul mode is active. Holding the turn signal
lever for more than one second will cause the turn
signals to flash until you release the lever. The lever
will return by itself when it is released.