Windshield Washer Fluid - Hummer H3T Owner's Manual

04AKENG59_H3T.fm Page 294 Thursday, July 31, 2008 12:07 PM
Service and Maintenance
The level should be between the
MIN and MAX marks.
Low fluid level can indicate a leak
in the brake system. Have the
vehicle serviced as soon as
possible.
If work has just been done on the
brake hydraulic system and the
fluid level is low, bring it up to the
proper level using DOT-3 fluid
from a sealed container.
See "Recommended Fluids and
Lubricants" later in this section.
To prevent contamination of the
brake fluid, make sure the brake
reservoir and cap are thoroughly
clean before removing the cap.
. . . 294
CAUTION
With the wrong kind of fluid in
your brake system, your brakes
may not work well. This could
cause a collision. Always use the
proper brake fluid.
NOTICE
Using the wrong kind of fluid
could severely damage system
components. Always use the
proper brake fluid.
Don't spill brake fluid on the
vehicle's exterior surfaces. It can
damage your paint. If you do,
wash it off immediately.

Windshield Washer Fluid

Use windshield washer solvent
®
such as GM Optikleen rather than
water to prevent freezing and for
better cleaning.
Add washer fluid until the tank is
full.