Retrying The Same Destination (Redial Tx) - NEC NEFAX 805 Operation Manual

Basic FAX Operation (2)
NOTE:
The following message appears if the memory becomes full while the fax is
scanning a document.
*MEM.FULL/TX CANCEL*
0123456789
•
If you would like to transmit the portion of the document stored in memory,
press the Start key to perform transmission. The machine transmits the portion
of the document, which is store in memory.
•
If you want to delete the portion of the document, which was stored in memory,
press the Yes key to select CANCEL. This deletes the contents of the document.
•
If you fail to make a choice within 1 min. after the above message has appeared,
the contents of the document will be automatically deleted.
NOTE:
•
When transmitting a document using Direct TX mode, and if the line is busy,
LCD will display REDIAL WAITING and wait for the time interval to redial,
you can press STOP Key to cancel the transmission, but your machine would
not print out an error report.
•
In Direct transmission mode, if the redials all fail, your machine would not
print out an error report too.

4.2. Retrying the Same Destination (Redial TX)

Redial TX would display the destination that the machine has previously dialed, but not
connected to. The following two sub-features are available.
1) Auto Redial
If the line is busy, the machine stops dialing and, several seconds later, it dials the party
again. This redialing sequence is repeated several times.
2) Manual Redial
The last dialed is redial by press the Redial/Pause key.
NOTE:
•
Auto Redial has been factory-set , so you needn't to set it. Auto Redial has been factory-set , so you needn't to set it.
• •
The redial interval time and number of redials are depending on the The redial interval time and number of redials are depending on the
country in which the machine is used. Consult your Tech. Rep. for more country in which the machine is used. Consult your Tech. Rep. for more
details. details.
Fax screen Copy screen
TEXT
4-2
1
Fax:Err