Table of Contents
Advertisement
Connect to PC
1) Class 1 interface
A serial port (RS232C) connection is required for this to work.
-PC end: in conformance with your PC
- Machine end: 9-pin D-SUB male.
2) Setting up Class 1
To ensure your machine can work with the Class 1 software correctly,
make sure the No. of rings setting in your machine is greater then the
setting in Class 1 soft ware.
Most Class 1 software setting the number of rings=2, so you have to set
your machine a greater number of rings. For example: 6.
Refer "Setting No. of Rings"
P 7-21
10-4
Advertisement
Table of Contents
