Program Dial - NEC NEFAX 805 Operation Manual

Using the Enhanced Utilities (1)
4. When the transmission is completed, a
buzzer sounds once and a message
indicating that the transmission has been
normally completed appears and remains
shown for 2 sec. Then, the initial screen
reappears.
TX Result Report is then Printed. P 9-7
If the Line is busy:
If the line of a particular party is busy, the machine puts that party at the end of the
transmission sequence.
When the initial transmission attempts are
completed for all destinations, the machine redials
the destinations that were busy previously, for
transmission of the document.
If the Transmission was Unsuccessful:
If the fax failed in transmitting the document to a destination, a buzzer sounds intermittently
for 2 sec. and the Error indicator lights up.
It then prints a TX/RX Result Report
automatically. For details, see "TX/RX Result
Report.
Then it will redial to the destination again, until it
successful transmits or it had already redials 9 times.

6.2.3 Program Dial

The Broadcast, Timer TX, Mailbox TX, Polling RX or Relay Initiate function can be
registered in Program Dial.
Program Dial allows you to transmit a document using a particular transmission function
previously registered. This eliminates job setup for frequently performed tasks.
Program Dial accommodates up to five different transmission functions. One Touch keys
that can be used for this purpose are 24, 25, 26, and 27.
For details of each function, see the relevant page.
Broadcast: P 5-4; Timer TX:
NOTE:
Registering a Program Dial into a One Touch key to which One Touch Dial or
Group Dial or another Program Dial has previously been assigned, will overwrite
the original data.
P 5-11; Mailbox TX:
6-15
* TX COMPLETE *
* REDIAL WAITING *
JAPAN
* REDIAL ALL FAILED *
TOKYO
P 5-14; Polling RX: P 5-23