Terminal Legs; Using The Terminal Legs; Adjusting The Leg Height (Figure 4-41 - Figure 4-42) - NEC UX5000 Hardware Manual

Hide thumbs Also See for UX5000:
Table of Contents

Advertisement

S
4-19
ECTION

TERMINAL LEGS

4.19.1

Using the Terminal Legs

The UX5000 terminals provide two legs for angling the terminal to best suit each user (this is in addition to the
display positioning provided by display terminals). The legs can be set for four different heights.
4.19.2

Adjusting the Leg Height (Figure 4-41 - Figure 4-42)

1.
When first placing a terminal, the upper and lower legs are folded out flat. Rotate the lower leg (located at
the front of the terminal) towards the back. Lower the upper leg down and gently press the left and right
sides into the lower leg. Note that the upper leg has 2 small tabs that fit into notches on the lower leg.
After positioning these tabs over the notches, gently press the upper leg down until it clicks into place in
the lower leg. This is the first position.
2.
To set to the second, third, and forth positions, gently press the lower leg down untiil the upper leg clicks
into the desired position..
3.
To set the terminal back to a lower position, first gently press the lower leg down to unsecure the upper
leg. Then gently lift the upper leg up and slide it to the desired position.
Chapter 4
Figure 4-41: RAISING THE TERMINAL HEIGHT
Figure 4-42: INCREASING THE TERMINAL HEIGHT
Chapter 4 - Terminals and Optional Equipment
4 - 83

Advertisement

Table of Contents
loading

Table of Contents