NEC UX5000 Hardware Manual page 104

Chapter 2 - Blade Installation and Startup
Connector
CN6/SW2
CN8/CN9
LOAD/SW1
The CCPU without a MEMDB attached supports:
•
•
•
•
The CCPU with a MEMDB attached and limited port licensing supports:
•
•
•
•
The CCPU with a MEMDB attached and full port licensing supports:
•
•
•
•
2 - 18
CN1 Backboard Connection
CN2 MEMDB-A1 (Expanded Memory) Connection
VOIPDB Blade Connection
CN3
CN4 VMBU Blade Connection
CN5 USB Memory Connection (used for upgrading software or downloading system
data)
Used for Debug Purposes
CN7 Ethernet Cable Connection (for PCPro or WebPro, CTI, ACD MIS, IP Phone)
Pin Sub-Mini Jack for External Source Connection (External MOH, External
Speaker, etc.)
External Source Control Connection
CN10
Load Switch
BAT Lithium Battery Socket (for backup of SRAM memory data)
CCPU Setup Dip Switches (normally left as is)
SW6
64 Ports for IP/Digital Trunks/
Extensions
Expansion Chassis
VOIPDB
8 IntraMail/VRS Ports
256 Ports for IP/Digital Trunks
(200 max.) / Extensions
(256 max.)
Expansion Chassis
VOIPDB
16 IntraMail/VRS Ports
712 Ports for IP/Digital Trunks
(200 max.) / Extensions
(512 max.)
Expansion Chassis
VOIPDB
16 IntraMail/VRS Ports
Connector Description
• BRI S-Bus/T-Bus
• PRI Trunks
• T1 Trunks
• Tie Line Trunks
• (1) 082U Blade
• BRI S-Bus/T-Bus
• PRI Trunks
• T1 Trunks
• Tie Line Trunks
• Multiple 082U Blades
(1 per 9.5" base chassis
or 1 per 19" chassis max.)
• BRI S-Bus/T-Bus
• PRI Trunks
• T1 Trunks
• Tie Line Trunks
• Multiple 082U Blades
(1 per 9.5" base chassis
or 1 per 19" chassis max.)
• ACD/inDepth
• Third-Party CTI/TAPI 2
• ACD/inDepth
• Networking (CygniLink
and AspireNet)
• Recovery Point
• Remote Maintenance
• Third-Party CTI/TAPI 2
• ACD/inDepth
• Networking (CygniLink
and AspireNet)
• Recovery Point
• Remote Maintenance
• Third-Party CTI/TAPI 2
Chapter 2