Removing The Exifu Cover (Figure 2-8); To Install An Exifu Blade - NEC UX5000 Hardware Manual

2.4.2.2

Removing the EXIFU Cover (Figure 2-8)

1.
2.4.2.3

To install an EXIFU blade:

1.
2.
3.
4.
Chapter 2
Press on the right-hand side of the EXIFU cover and pull the cover open. Slide the cover
slightly to the left to unhook the 3 hooks which hold on the cover.
Press here to pull
the cover.
Hooks
This cover has three Hooks
at the left hand side.
Figure 2-8:
• Do not remove or install this blade with the power on.
Remove the EXIFU cover as described previously from each of the chassis.
Carefully remove the blank filler piece on the cover to allow for the EXIFU connectors.
For the Controlling Chassis-B1 (with the CCPU), install the EXIFU-B1 into the slot.
For the Base Chassis-B1(s), install the EXIFU-E1 into the slot in each of the additional
chassis. Screw the blade to the chassis using the screw provided.
Chapter 2 - Blade Installation and Startup
REMOVING THE EXIFU COVER
2 - 25