Removing A Fixed-Height Stand; Attaching And Removing An Adjustable Height Stand; Attaching An Adjustable Height Stand - HP ProOne 600 Hardware Reference Manual

Hp proone 600 g4 21.5-inch all-in-one business pc hp proone 400 g4 23.8-inch all-in-one business pc hp proone 400 g4 20-inch all-in-one business pc

Hide thumbs Also See for ProOne 600:

Table of Contents

Rotate the stand down until it clicks into place (2).

Removing a fixed-height stand

To remove the stand:

Remove all removable media, such as optical discs or USB flash drives, from the computer.

Turn off the computer properly through the operating system, then turn off any external devices.

Disconnect the AC power cord from the AC outlet and disconnect any external devices.

Place the computer facedown on a soft flat surface. HP recommends that you set down a blanket, towel,

or other soft cloth to protect the bezel and screen surface from scratches or other damage.

Press the stand release latch.

Rotate the stand away from the computer (1).

Slide the stand hooks out of the computer (2).

To install the stand:

Place the computer facedown on a soft flat surface. HP recommends that you set down a blanket, towel,

or other soft cloth to protect the bezel and screen surface from scratches or other damage.

Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the

computer (1).

Chapter 2 Setup

Table of Contents

Proone 400