Adjusting The Shift Pedal - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
A
B
A. Front brake caliper
B. Rear brake caliper
d. Place the other end of the hose into a con-
tainer.
e. Slowly apply the brake several times.
f. Fully pull the brake lever or fully press down
the brake pedal and hold it in position.
g. Loosen the bleed screw.
NOTE:
Loosening the bleed screw will release the pres-
sure and cause the brake lever to contact the
throttle grip or the brake pedal to fully extend.
h. Tighten the bleed screw and then release the
brake lever or brake pedal.
i. Repeat steps (e) to (h) until all of the air bub-
bles have disappeared from the brake fluid in
the plastic hose.
j. Tighten the bleed screw to specification.
Bleed screw (front brake caliper)
6 Nm (0.6 m·kg, 4.3 ft·lb)
Bleed screw (rear brake caliper)
6 Nm (0.6 m·kg, 4.3 ft·lb)
k. Fill the brake fluid reservoir to the proper level
with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-21.
Email: info@motomatrix.co.uk
2
1
2
1
3-24
EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
L LLL L LLL L L LLL L L LLL
3. Install:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21380

ADJUSTING THE SHIFT PEDAL

NOTE:
The shift pedal position is determined by the in-
stalled shift rod length "a".
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
309.2–311.2 mm (12.17–12.25 in)
2. Adjust:
• Installed shift rod length
M MMM M MMM M M MMM M M MMM
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" until
the specified installed shift rod length is ob-
tained.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
CHASSIS
L L LLL L L LLL L LLL
a
M M MMM M M MMM M MMM