Yamaha MT-01 Service Manual page 449

Manuals by Motomatrix / www.motomatrix.co.uk
To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
Odometer and tripmeter modes
1. Odometer/Tripmeter/Fuel reserve tripmeter
Pushing the "SELECT" button switches the dis-
play between the odometer mode "ODO" and
the tripmeter modes "TRIP 1" and "TRIP 2" in the
following order:
ODO → TRIP 1 → TRIP 2 → ODO
If the fuel level warning light comes on, the
odometer display will automatically change to
the fuel reserve tripmeter mode "F-TRIP" and
start counting the distance traveled from that
point. In that case, pushing the "SELECT" button
switches the display between the various tripme-
ter and odometer modes in the following order:
F-TRIP → TRIP 1 → TRIP 2 → ODO → F-TRIP
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RESET" but-
ton for at least one second. If you do not reset
the fuel reserve tripmeter manually, it will reset
itself automatically and the display will return to
the prior mode after refueling and traveling 5 km
(3 mi).
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
multi-function display will indicate a two-digit er-
ror code (e.g., 12, 13, 14).
Email: info@motomatrix.co.uk
If the multi-function display indicates an error
code, note the code number, and then check the
vehicle. Refer to "FUEL INJECTION SYSTEM"
on page 7-25.
EC5YU1010
CAUTION:
If the multi-function display indicates an er-
ror code, the vehicle should be checked as
soon as possible in order to avoid engine
damage.
This model is also equipped with a self-diagno-
sis device for the immobilizer system.
If any of the immobilizer system circuits are de-
fective, the immobilizer system indicator light will
flash, and then the multi-function display will in-
dicate a two-digit error code (e.g., 51, 52, 53)
when the key is turned to "ON".
NOTE:
1
If the multi-function display indicates error code
52, this could be caused by transponder interfer-
ence. If this error appears, try the following.
1. Use the code re-registering key to start the
engine.
NOTE:
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off, and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, re-register the standard keys.
If the multi-function display indicates an error
code, note the code number, and then check the
vehicle. Refer to "IMMOBILIZER SYSTEM" on
page 7-75.
1-5
FEATURES