Yamaha MT-01 Service Manual page 539

Manuals by Motomatrix / www.motomatrix.co.uk
4. Adjust:
• EXUP cable free play
M MMM M MMM M M MMM M M MMM
a. Slide back the rubber cover.
b. Loosen both locknuts "1".
1
c. Insert a 3.5 mm (0.14 in) pin "2" through the
projections "a" in the EXUP valve pulley and
into the hole "b" in the EXUP valve cover.
2
d. Turn both adjusting nuts "3" in or out until the
specification.
Turn in "c" →
Free play is increased.
Turn out "d" →
Free play is decreased.
d d c c
d d
3
e. Tighten both locknuts and then slide the rub-
ber cover to its original position.
f. Remove the pin.
g. Turn the main switch to "ON", check that the
EXUP valve pulley contacts the stoppers (ful-
ly-open and fully-closed positions), and then
Email: info@motomatrix.co.uk
M M MMM M M MMM M MMM
1
a
b
3
c
check that the notch in the EXUP valve pulley
is aligned with the hole in the EXUP valve
cover.
L LLL L LLL L L LLL L
5. Install:
• EXUP valve pulley cover
EXUP valve pulley cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
3-19
ENGINE
L LLL L L LLL L L LLL L LLL