Adjusting The Shift Pedal; Adjusting The Drive Chain Slack - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
NOTE:
Loosening the bleed screw will release the pres-
sure and cause the brake lever to contact the
throttle grip or the brake pedal to fully extend.
h. Tighten the bleed screw and then release the
brake lever or brake pedal.
i. Repeat steps (e) to (h) until all of the air bub-
bles have disappeared from the brake fluid in
the plastic hose.
j. Tighten the bleed screw to specification.
Bleed screw (front brake master
cylinder)
6 Nm (0.6 m·kg, 4.3 ft·lb)
Bleed screw (front brake caliper)
6 Nm (0.6 m·kg, 4.3 ft·lb)
Bleed screw (rear brake caliper)
6 Nm (0.6 m·kg, 4.3 ft·lb)
k. Fill the brake fluid reservoir to the proper level
with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-21.
EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
L LLL L LLL L L LLL L L LLL
EAS21380

ADJUSTING THE SHIFT PEDAL

NOTE:
The shift pedal position is determined by the in-
stalled shift rod length "a".
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
309.2–311.2 mm (12.17–12.25 in)
2. Adjust:
• Installed shift rod length
Email: info@motomatrix.co.uk
L L LLL L L LLL L LLL
a
M MMM M MMM M M MMM M
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" until
the specified installed shift rod length is ob-
tained.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
1
c. Tighten both locknuts to specification.
Locknut (shift rod)
7 Nm (0.7 m·kg, 5.1 ft·lb)
L LLL L LLL L L LLL L
EAS21390

ADJUSTING THE DRIVE CHAIN SLACK

ECA13550
CAUTION:
A drive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the swing-
arm or cause an accident. Therefore, keep
the drive chain slack within the specified lim-
its.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Check:
• Drive chain slack "a"
Out of specification → Adjust.
Drive chain slack
40.0–50.0 mm (1.57–1.97 in)
3-24
CHASSIS
M MMM M M MMM M M MMM M
2
b
a
L LLL L L LLL L L LLL L
MMM
LLL