Replacing The Air Filter Element - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
• If bleeding is difficult, it may be necessary to let
the clutch fluid settle for a few hours. Repeat
the bleeding procedure when the tiny bubbles
in the hose have disappeared.
1. Bleed:
• Hydraulic clutch system
M MMM M MMM M M MMM M M MMM
a. Add the recommended clutch fluid to the
proper level.
b. Install the clutch master cylinder reservoir di-
aphragm.
c. Connect a clear plastic hose "1" tightly to the
bleed screw "2".
d. Place the other end of the hose into a con-
tainer.
e. Slowly squeeze the clutch lever several
times.
f. Fully squeeze the clutch lever without releas-
ing it.
g. Loosen the bleed screw. This will release the
tension and cause the clutch lever to contact
the handlebar grip.
h. Tighten the bleed screw and then release the
clutch lever.
i. Repeat steps (e) to (h) until all of the air bub-
bles have disappeared from the clutch fluid in
the plastic hose.
j. Tighten the bleed screw to specification.
Bleed screw (clutch release cylin-
der)
6 Nm (0.6 m·kg, 4.3 ft·lb)
k. Add the recommended clutch fluid to the
proper level.
Refer to "CHECKING THE CLUTCH FLUID
LEVEL" on page 3-14.
EWA13010
WARNING
After bleeding the hydraulic clutch system,
check the clutch operation.
L LLL L LLL L L LLL L L LLL
Email: info@motomatrix.co.uk
M M MMM M M MMM M MMM
2
1
L L LLL L L LLL L LLL
EAS20960

REPLACING THE AIR FILTER ELEMENT

1. Remove:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
2. Lift the front of the fuel tank, and then tilt it
back and away from the air filter case. (Do not
disconnect the fuel hoses.)
3. Remove:
• Air filter case cover "1"
4. Remove:
• Air filter element "1"
5. Check:
• Air filter element
Damage → Replace.
NOTE:
• Replace the air filter element every 40000 km
of operation.
• The air filter needs more frequent service if you
are riding in unusually wet or dusty areas.
3-15
ENGINE
1
1