Yamaha MT-01 Service Manual page 607

Manuals by Motomatrix / www.motomatrix.co.uk
EAS22960
REMOVING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
front wheel is elevated.
2. Loosen:
• Upper bracket pinch bolt "1"
• Cap bolt "2"
• Lower bracket pinch bolt "3"
EWA13640
WARNING
Before loosening the upper and lower brack-
et pinch bolts, support the front fork leg.
EAS22990
DISASSEMBLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
Email: info@motomatrix.co.uk
1. Position the collar "1" as shown in the illustra-
2. Remove:
M
a. Press down on the spacer with the fork spring
b. Install the rod holder "5" between the nut "3"
2
1
NOTE:
Use the side of the rod holder that is marked "B".
3
c. Hold the spring preload adjusting bolt "6" and
EC5YU1011
When loosening the nut "3", be sure not to
break the projections "a" on the collar "7" of
the cap bolt "1".
4-49
tion by turning the spring preload adjusting
bolt "2" counterclockwise until it stops.
2
1
• Cap bolt "1"
(from the damper adjusting rod)
• Spacer "2"
• Nut "3"
MMM M MMM M M MMM M M MMM
compressor "4".
and the spacer "2".
Fork spring compressor
90890-01441
YM-01441
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
2
4
loosen the nut "3".
CAUTION:
FRONT FORK
M M MMM M M MMM M MMM
1
3
5