Yamaha MT-01 Service Manual page 662

Manuals by Motomatrix / www.motomatrix.co.uk
A. Rear cylinder
B. Front cylinder
1. Intake side rocker arm
2. Exhaust side rocker arm
3. Intake valve lifter
4. Exhaust valve lifter
5. Push rod 1 l = 288.5 mm (11.358 in)
6. Push rod 2 l = 290.5 mm (11.437 in)
c. Install the rocker arm base bolts (M6) "1", "2"
and the rocker arm base bolts (M8) "3".
NOTE:
Tighten the rocker arm base bolts in stages and
in a crisscross pattern.
Rocker arm base bolt (M6)
10 Nm (1.0 m·kg, 7.2 ft·lb)
Rocker arm base bolt (M8)
24 Nm (2.4 m·kg, 17 ft·lb)
Bolts "1": l = 36 mm (1.42 in)
Bolts "2": l = 40 mm (1.57 in)
L LLL L LLL L L LLL L L LLL
EAS24080
INSTALLING THE CYLINDER HEAD
COVERS
The following procedure applies to both cylin-
ders.
1. Install:
• Front cylinder head cover "1"
• Rear cylinder head cover "2"
Email: info@motomatrix.co.uk
L L LLL L L LLL L LLL
NOTE:
Apply locking agent (LOCTITE
of the bolt "3".
Cylinder head cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
Bolts "3", "4": l = 40 mm (1.57 in)
Bolts "5": l = 50 mm (1.97 in)
Bolt with washer "6": l = 50 mm (1.97 in)
Bolts "7": l = 60 mm (2.36 in)
7
3
LT
5
3
LT
7
2. Install:
• Tappet covers "1"
NOTE:
Install the tappet covers with their "UP" marks "a"
facing each other.
Tappet cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
5-30
CAMSHAFTS
®
) to the threads
5
4
1
4
7
5
6 7
4
2
4
5
6
1 a
UP
a
1