Yamaha MT-01 Service Manual page 176

Manuals by Motomatrix / www.motomatrix.co.uk
10.Fully compress the front fork leg.
11.Fill:
• Front fork leg
(with the specified amount of the recom-
mended fork oil)
Quantity
583.0 cm³ (19.71 US oz) (20.56
Imp.oz)
Recommended oil
Suspension oil 01
ECA14230
CAUTION:
• Be sure to use the recommended fork oil.
Other oils may have an adverse effect on
front fork performance.
• When disassembling and assembling the
front fork leg, do not allow any foreign ma-
terial to enter the front fork.
12.After filling the front fork leg, slowly stroke the
damper rod "1" up and down (at least ten
times) to distribute the fork oil.
NOTE:
Be sure to stroke the damper rod slowly be-
cause the fork oil may spurt out.
13.Before measuring the fork oil level, wait ten
minutes until the oil has settled and the air
bubbles have dispersed.
NOTE:
Be sure to bleed the front fork leg of any residual
air.
Email: info@motomatrix.co.uk
14.Measure:
• Front fork leg oil level "a"
(from the top of the inner tube, with the outer
tube fully compressed and without the fork
spring)
Out of specification → Correct.
Level
65.0 mm (2.56 in)
15.Install:
• Lower spring seat "1"
• Fork spring "2"
• Upper spring seat "3"
• Nut "4"
• Spacer "5"
• Damper adjusting rod "6"
• Washer "7"
• Cap bolt "8"
(with O-ring)
5
4
7
8
3
M MMM M MMM M M MMM M
a. Remove the rod puller attachment.
b. Install the lower spring seat.
c. Install the fork spring.
NOTE:
Install the spring with the smaller pitch "a" facing
up "A".
4-54
FRONT FORK
a
1
2
6
M MMM M M MMM M M MMM M MMM