Yamaha MT-01 Service Manual page 167

Manuals by Motomatrix / www.motomatrix.co.uk
Grip end
29 Nm (2.9 m·kg, 21 ft·lb)
M MMM M MMM M M MMM M M MMM
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
NOTE:
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
L LLL L LLL L L LLL L L LLL
6. Install:
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
1
7. Install:
• Clutch master cylinder assembly
• Clutch master cylinder holder "1"
Clutch master cylinder holder
bolt
13 Nm (1.3 m·kg, 9.4 ft·lb)
Email: info@motomatrix.co.uk
M M MMM M M MMM M MMM
L L LLL L L LLL L LLL
b
a
NOTE:
• Align the mating surfaces of the clutch master
cylinder holder with the punch mark "a" on the
handlebar.
• First, tighten the upper bolt, then the lower bolt.
• The clutch master cylinder holder has a punch
mark "b" to distinguish it from the front brake
master cylinder holder.
1
b
8. Install:
• Throttle grip
• Throttle cables
• Right handlebar switch "1"
• Grip end "2"
Grip end
29 Nm (2.9 m·kg, 21 ft·lb)
NOTE:
• Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
• There should be 1–3 mm (0.04–0.12 in) of
clearance "c" between the throttle grip and the
grip end.
a
4-45
HANDLEBAR
a
b
1