Assembling The Rear Wheel; Checking The Rear Brake Disc; Installing The Rear Wheel (Rear Brake Disc) - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
b. Correct
1. Drive chain roller
2. Rear wheel sprocket
2. Replace:
• Rear wheel sprocket
M MMM M MMM M M MMM M M MMM
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket self-locking
nut
100 Nm (10 m·kg, 72 ft·lb)
NOTE:
Tighten the self-locking nuts in stages and in a
crisscross pattern.
L LLL L LLL L L LLL L L LLL
EAS22140

ASSEMBLING THE REAR WHEEL

1. Install:
New
• Wheel bearings
• Oil seals New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-9.
Email: info@motomatrix.co.uk
M M MMM M M MMM M MMM
L L LLL L L LLL L LLL
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-9.
ET5YU1026

CHECKING THE REAR BRAKE DISC

Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-35.
EAS22160
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
Rear brake disc bolt
18 Nm (1.8 m·kg, 13 ft·lb)
LOCTITE
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-35.
3. Lubricate:
• Oil seal lips
• Collars
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Collar (wheel sprocket side) "1"
4-16
REAR WHEEL
®