Replacing The Front Brake Pads - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
L LLL L LLL L L LLL L L LLL
6. Install:
• Front wheel
Refer to "FRONT WHEEL" on page 4-6.
EAS22270

REPLACING THE FRONT BRAKE PADS

The following procedure applies to both brake
calipers.
NOTE:
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disassem-
ble the brake caliper.
1. Measure:
• Brake pad wear limit "a"
Out of specification → Replace the brake
pads as a set.
Brake pad lining thickness (in-
ner)
4.5 mm (0.18 in)
Limit
0.8 mm (0.03 in)
Brake pad lining thickness (out-
er)
4.5 mm (0.18 in)
Limit
0.8 mm (0.03 in)
Email: info@motomatrix.co.uk
L L LLL L L LLL L LLL
a
2. Install:
• Brake pads
• Brake pad springs
NOTE:
Always install new brake pads and brake pad
springs as a set.
M MMM M MMM M M MMM M
a. Connect a clear plastic hose "1" tightly to the
bleed screw "2". Put the other end of the hose
into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with your
finger.
1
c. Tighten the bleed screw.
Bleed screw (front brake caliper)
6 Nm (0.6 m·kg, 4.3 ft·lb)
d. Install new brake pads and new brake pad
springs.
NOTE:
The arrow marks "a" on the brake pad springs
must point in the direction of disc rotation.
4-24
FRONT BRAKE
a
a
M MMM M M MMM M M MMM M
2
MMM