Yamaha MT-01 Service Manual page 82

Manuals by Motomatrix / www.motomatrix.co.uk
1. Cylinder-#2 intake air pressure sensor
2. Cylinder-#2 ISC (idle speed control) unit outlet
hose
3. ISC (idle speed control) unit
4. Intake solenoid vacuum hose (one-way valve to
throttle body)
5. Cylinder-#1 ISC (idle speed control) unit outlet
hose
6. Throttle position sensor
7. Throttle body
8. Cylinder-#1 intake air pressure sensor hose
9. Fuel return hose
10. Pressure regulator
11. Cylinder-#1 intake air pressure sensor
12. Clutch hose
13. Cylinder-#2 intake air pressure sensor hose
14. Fuel hose
15. Air filter case
16. Pressure regulator joint
17. Fuel hose (intake manifold assembly to pressure
regulator)
A. Face the ends of the hose clamp outward.
B. Face the ends of the hose clamp rearward.
C. Install the end of the cylinder-#1 ISC (idle speed
control) unit outlet hose with a white paint mark
onto the throttle body.
D. Face the ends of the hose clamp to the left, angled
°
45 towards the rear of the vehicle.
E. Face the ends of the hose clamp forward.
F. Install the end of the cylinder-#1 intake air pressure
sensor hose with a white paint mark onto the
throttle body.
G. Face the ends of the hose clamp inward.
H. Face the ends of the hose clamp forward.
I. Face the ends of the hose clamp to the right,
°
angled 45 towards the front of the vehicle.
J. Face the ends of the hose clamp forward.
K. Face the ends of the hose clamp inward.
L. Install the end of the intake solenoid vacuum hose
(one-way valve to throttle body) with a white paint
mark onto the throttle body. Be sure to install the
end of the hose all the way onto the throttle body
and position the hose clamp as shown in the
illustration.
°
M. 45
N. 1 mm (0.04 in)
Email: info@motomatrix.co.uk
2-56
CABLE ROUTING