Specifications Generator Ratings - Jeep 1996 Grand Cherokee Service Manual

8C - 8 CHARGING SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 5 Remove/Install Generator Connectors—
BATTERY TEMPERATURE SENSOR
The battery temperature sensor is located under
vehicle battery (Fig. 6) and is attached to a mounting
hole on battery tray.
REMOVAL
(1) Remove the battery. Refer to Group 8A, Battery
for procedures.
SPECIFICATIONS
GENERATOR RATINGS
TYPE PART NUMBER
DENSO 56005685
DENSO 56005686
DENSO 56027912
DENSO 56027913
TORQUE SPECIFICATIONS
Description
Generator Mounting Bolt—
5.2L Engine . . . . . . . . . . . . . . . .41 N·m (30 ft. lbs.)
Generator Pivot Bolt—
5.2L Engine . . . . . . . . . . . . . . . .41 N·m (30 ft. lbs.)
Generator Mounting Bolt—
4.0L Engine . . . . . . . . . . . . . . . .55 N·m (41 ft. lbs.)
Typical
RATED SAE AMPS
Fig. 6 Battery Temperature Sensor Location
(2) Disconnect the sensor pigtail harness from the
engine wire harness.
(3) Pry the sensor straight up from the battery
tray mounting hole.
INSTALLATION
(1) Feed the pigtail harness through the hole in
top of battery tray and press sensor into top of bat-
tery tray.
(2) Connect the pigtail harness.
(3) Install the battery. Refer to Group 8A, Battery
for procedures.
117
136
117
136
Torque Description
Generator Pivot Bolt—
4.0L Engine . . . . . . . . . . . . . . . .55 N·m (41 ft. lbs.)
Battery Terminal Nut . . . . . . . . .8.5 N·m (75 in. lbs.)
Ground Terminal Nut . . . . . . . . .8.5 N·m (75 in. lbs.)
Harness Hold-down Nut . . . . . . .8.5 N·m (75 in. lbs.)
Field Terminal Nuts . . . . . . . . . .2.8 N·m (25 in. lbs.)
ENGINES MINIMUM TEST
4.0L
4.0L
5.2L
5.2L
ZJ
AMPS
90
120
90
120
Torque